Lenovo CN4093 Application Manual page 319

3. For each desired zoneset:
Activating Zoneset
© Copyright Lenovo 2015
Repeat as necessary for each member device.
c. Exit from zone configuration:
CN 4093(config-zone)# exit
a. Name (or remove) the zoneset.
CN 4093(config)# [no] zoneset name <zoneset name>
b. Add (or remove) one or more member zones to the zoneset:
CN 4093(config-zoneset)# [no] member <zone name>
Repeat as necessary for each member zone.
c. Exit from zoneset configuration:
CN 4093(config-zone)# exit
Fibre Channel is intended to operate with minimal disruption. To prevent the
various synchronization events that would result if each stage of a live zoning
configuration was applied, the cumulative configuration changes for zones and
zoneset are held in reserve until explicitly activated by the administrator.
When activated, the new zoneset will be synchronized throughout the Fibre
Channel fabric for each modified zone. Fibre Channel traffic will be temporarily
disrupted in modified zones as changes to the fabric are recognized by the
connected devices. Until activation, the previously established zoneset will remain
in effect.
The basic zoneset commands are as follows:
 Activate or deactivate a zoneset:
CN 4093(config)# [no] zoneset activate name <zoneset name>
 View the settings for the active zoneset:
CN 4093# show zoneset active
 View the settings for the pending configuration changes:
CN 4093# show zoneset
Chapter 18: Fibre Channel
319