Example 4: Auto-Vlan Mode With Edge Virtual Bridging - Lenovo CN4093 Application Manual

11. Verify the virtual machine settings.
12. Add the virtual machine associated with the vPort to the VMGroup.
13. Verify the VMGroup associations.

Example 4: Auto-VLAN Mode with Edge Virtual Bridging

1. Turn on UFP.
2. Configure internal port 1 as UFP.
3. Configure a vPort.
4. Configure the vPort's default VLAN.
5. Set the vPort to tunnel mode.
6. Configure the EVG profile for the vPort.
7. Specify QoS parameters for the vPort.
354
CN4093 Application Guide for N/OS 8.3
CN4093(config)# show virt vm
CN4093(config)# virt vmgroup 1 vm 1
CN4093(config)# show virt vm
Following is an example configuration of UFP vPorts in auto mode.
CN 4093(config)# ufp enable
CN4093(config)# ufp port INTA1 enable
Warning: "Tagging/Trunk-mode" is enabled on UFP port INTA1
CN4093(config_ufp_vport)# ufp port INTA1 vport 1
CN4093(config_ufp_vport)# network default-vlan 20
CN4093(config_ufp_vport)# network mode auto
Note: VLAN is dynamically added by 802.1Qbg.
CN4093(config_ufp_vport)# evb profile 1
CN4093(config_ufp_vport)# qos bandwidth min 10
CN4093(config_ufp_vport)# qos bandwidth max 80
(in percentage)
(in percentage)