Setup Part 2: Port Configuration - Lenovo CN4093 Application Manual

Setup Part 2: Port Configuration

1. Select whether you will configure VLANs and VLAN tagging for ports:
2. Select the port to configure, or skip port configuration at the prompt:
3. Configure Gigabit Ethernet port flow parameters.
4. Configure Gigabit Ethernet port autonegotiation mode.
© Copyright Lenovo 2015
Note: When configuring port options for your switch, some prompts and options
may be different.
Port Config:
Will you configure VLANs and Tagging/Trunk-mode for ports? [y/n]
If you wish to change settings for VLANs, enter y or enter n to skip VLAN
configuration.
Note: The sample screens that appear in this document might differ slightly from
the screens displayed by your system. Screen content varies based on the type of
chassis unit that you are using and the firmware versions and options that are
installed.
If you wish to change settings for individual ports, enter the number of the port
you wish to configure. To skip port configuration, press <Enter> without
specifying any port and go to
The system prompts:
Gig Link Configuration:
Port Flow Control:
Current Port EXT1 flow control setting:
Enter new value ["rx"/"tx"/"both"/"none"]:
Enter rx to enable receive flow control, tx for transmit flow control, both to enable
both or none to turn flow control off for the port. To keep the current setting, press
<Enter>.
If you selected a port that has a Gigabit Ethernet connector, the system prompts:
Port Auto Negotiation:
Current Port EXT1 autonegotiation:
Enter new value ["on"/"off"]:
Enter on to enable port autonegotiation, off to disable it or press <Enter> to keep
the current setting.
"Setup Part 3: VLANs" on page
both
on
55.
53
Chapter 2: Initial Setup