Table of Contents
Advertisement
Chapter 5 Web GUI Setup and Monitoring
Setting up the ASI Input
1
From the user interface of the D9854/D9854-I, choose Input > Input Setup. The
Input Setup page is displayed.
2
Click the ASI tab.
3
Check the Use ASI Input check box to tune to the ASI input.
Note: Setting a new input to be active will deactivate the currently active input.
4
Click Apply.
Viewing the ASI Input Status
The ASI Input Status area displays the current ASI status. The following table
describes the ASI Input Status information displayed:
Parameter
Active Input
Signal Status
Input Rate (Mbps)
ASI Link
170
Description
Indicates the currently selected input source (RF1, RF2, RF3,
RF4, or ASI).
Indicates whether the input signal is locked.
Locked - Indicates the receiver is locked to a carrier
with no valid content.
Lock+Sig - Indicates the receiver is locked to a carrier
with valid content.
No Lock - Indicates the receiver is not locked to a
carrier.
Displays the bit rate of the input transport stream, in Mbps.
Indicates whether there is a transport stream link error (Error,
Ok, or N/A).
Advertisement
Table of Contents
