Communication Between Otosuite And Zodiac; Configuring The Immittance Module; Test Device Information - Madsen zodiac Reference Manual

• Annual calibration prompt
Choose when you wish to be reminded about the annual calibration.
• Protocol saving
Choose this item if you wish to permanently save changes made to a protocol.
• Language
Choose the language of your choice.
• About device
Choose this item to view information relating to the device.
2.4

Communication between OTOsuite and Zodiac

1. Make sure that the device is switched on.
2. Launch OTOsuite and activate the Control Panel. MADSEN Zodiacwill be connected automatically.
2.4.1

Configuring the Immittance module

You must run the Configuration Wizard before you can use the OTOsuite Immittance module and MADSEN Zodiac for the
first time.
You can also use the wizard later to change specific settings or, for example, to connect to another device.
Tools
1. Select
2. Click Configure
3. Enter your selections and click
configuration wizard.
Immittance
Select Immittance Device
2.4.2

Test device information

In OTOsuite
To see information relating to the test device, select
In Zodiac
Menu
> (missing or bad snippet) >
Otometrics - MADSEN Zodiac
Configuration Wizard
> ...
... next to Immittance .
Next
to continue the configuration or
1. Click to highlight the device you wish to use.
Next
2. Click
About Device
Finish
Close
to continue or to exit Immittance configuration.
Help About Device
> ... in the OTOsuite Immittance module.
2 Unpacking and installation
Applications
to return to the page of the
17