Powering The Device; Switching The Device On And Off - Madsen zodiac Reference Manual

Note If the probe check result does not show a value of 1.9 - 2.1 mmho/cc/cm
•
that you make an admittance calibration.
Probe home
You can mount the probe home on the wall, using the optional probe home wall-mount kit.
Powering
Powering the device ► 15
• See
Connecting to the PC
Connecting to the PC ► 16
• See
2.3.1

Powering the device

Zodiac is powered through an external power supply connected directly to the mains outlet.
Caution
•
Connecting the external power supply to Zodiac
Connecting the external power supply to the mains supply
Note The first time you switch on the device, leave it turned on for at least an hour to let the internal clock bat-
•
tery charge.
The first time you switch on the device, or if the device has been switched off for more than two weeks, the internal clock
runs out of power. When you start up the device, you will be prompted to set the time manually.
• Set the date and time as required on the device.
• Alternatively, you can connect to OTOsuite where it will be done automatically.
2.3.2

Switching the device on and off

Note The first time you switch on the device, leave it turned on for at least an hour to let the internal clock bat-
•
tery charge.
Otometrics - MADSEN Zodiac
.
.
Use only the power supply specified in
1. Connect the plug end of the external power supply cable to the external power supply socket on the
back of the device.
1. Connect the mains plug of the external power supply directly to an AC mains outlet with a three-wire
protective ground.
2. If applicable, switch on the mains supply.
Technical specifications ►
2 Unpacking and installation
3
/ml at 226 Hz, we recommend
129.
15