Operations; Operations And Interlocks - GE Multilin F650 Instruction Manual

5.8 RELAY CONFIGURATION
This menu option shows the setpoints for the 24 control operations that can be programmed, as follows:
• Select checkbox enables the desired operation.
• Command Text setpoint defines the command name.
• Interlocks Type setpoint defines the desired interlock type (An interlock is a condition that must be fulfilled for an
operation to be performed). The possible options are Logic or None. If the LOGIC option is selected, the program will
enable a new window for creating the logic. If the NONE option is selected, then the following setpoint (Interlockings)
will be irrelevant.
• Interlocks setpoint define the desired interlocks. This setpoint is enabled selecting the "logic" option in "Interlock
type". In the "Interlock logic" screen we can set the interlock logic, as shown on .
The setpoints on this screen allow creating a logic configuration with up to 3 AND gates and 1 OR gate for each of the
24 operations available in the relay. These setpoints are:
Select –
Source –
NOT –
5
• Final State Type setpoint: defines whether the operation requires (in addition to the interlock logic) any other
conditions to determine a "success condition". If so, we must select LOGIC. Otherwise, we must select NONE.
• Final State setpoint: defines the success condition of a programmed operation, if the previous setpoint (Final State
type) was set as LOGIC.
• Front Key setpoint: defines the front pushbutton from which the operation can be executed.
• Contact Input setpoint: defines whether the operation can be executed by digital input. It defines the digital input to be
used for this purpose.
• Virtual Output setpoint: defines whether the operation can be executed from a virtual output previously defined at the
logic configuration tool (PLC logic).
• Time Out setpoint: defines the period during which the operation command will remain activated waiting for a success
condition. If the success signal is received before this period expires, the command signal will be removed and the
timer reset. If the success condition is not received within this period of time, the operation is considered to be finished.
5-122
Enables/disables the selection for the interlock input
Selects a function, digital input, logic, etc. for defining each input of each AND gate.
Logic inverter
Figure 5–42: OPERATIONS AND INTERLOCKS
F650 Digital Bay Controller
5 SETPOINTS

5.8.3 OPERATIONS

GE Multilin