GE Multilin F650 Instruction Manual page 495

F.1 FACTORY DEFAULT CONFIGURATION
PRODUCT SETUP>COMMUNICATION SETTINGS >IEC 870-5-104
SETTING DESCRIPTION
Enable or disable the protocol
operation
Listening TCP port in the relay
Address in the ASDU header
Number of seconds for instantaneous
meterings
Not implemented
IEC 870-5-104 NOTES
Note 1: Cyclic Meter Period
SETPOINT > PRODUCT SETUP > FAULT REPORT
SETTING DESCRIPTION
Function permission
Positive sequence impedance module Pos Seq Module
Positive sequence impedance angle
Zero sequence impedance module
Zero sequence impedance angle
Line length
Display fault on HMI
Snapshot Event generation
F
F-4
NAME DEFAULT VALUE
Function DISABLED
TCP Port 2404
Common Addr of
255
ASDU
Cyclic Meter Period 0
Synchronization Event 0
0 value means no spontaneous meterings
NAME DEFAULT VALUE
Function DISABLED
3.00
Pos Seq Angle 75
Zero Seq Module 9.00
Zero Seq Angle 75
Line Length 100.0
Show Fault On HMI DISABLED
Snapshot Events ENABLED
F650 Digital Bay Controller
STEP RANGE
N/A [DISABLED – ENABLED]
N/A [0 : 65535]
N/A [0 : 65535]
1 s [0 : 3600]
N/A [0 : 3600]
STEP RANGE
N/A [DISABLED – ENABLED]
0.01 Ohm [0.01 : 250.00]
1 Deg [25 : 90]
0.01 Ohm [0.01 : 750.00]
1 Deg [25 : 90]
0.1 [0.0 : 2000.0]
N/A [DISABLED – ENABLED]
N/A [DISABLED – ENABLED]
APPENDIX F
USER
VALUE
USER
VALUE
GE Multilin