GE Multilin F650 Instruction Manual page 361

10.1 EXAMPLE1: COMMUNICATION & PROTECTION SETTINGS PROCEDURE
Move rotating knob clockwise
Move rotating knob clockwise
Move rotating knob clockwise
Move rotating knob clockwise
Move rotating knob clockwise
Move rotating knob clockwise
Move rotating knob clockwise
Move rotating knob clockwise
Move rotating knob clockwise
Move rotating knob clockwise
Move rotating knob clockwise
Press ESC key once.
Move rotating knob counterclockwise to General Settings and press it down. General Settings 0 will be displayed now.
Press rotating knob down again.
Set ModBus Port Number to 502 and press rotating knob down.
Move counterclockwise the rotating knob to find ModBus Address COM1 and press it down.
Set ModBus Address COM1 to 254 with the rotating knob and then press it down.
Move clockwise the rotating knob to find Press Intro to End and press it down to validate the setting.
Connect a crossover 10/100 MB Ethernet cable from PC to the relay.
Open the EnerVista 650 SETUP program in the PC and under Communication ⇓ Computer menu and set:
IP Address
Port
Unit Identifier
Control Type to
Startup Mode to
Click ON key.
The program will start connection with the relay showing the progress screen.
10
10-2
IP Address OCT 3
IP Address OCT 4
Netmask OCT 1
Netmask OCT 2
Netmask OCT 3
Netmask OCT 4
Netway IP OCT 1
Netway IP OCT 2
Netway IP OCT 3
Netway IP OCT 4
Press INTRO
192.168.37.125
502
254
ModBus/TCP
Communicate with relay
F650 Digital Bay Controller
10 APPLICATION EXAMPLES
Set to 37 with rotating knob and press it down
Set to 125 with rotating knob and press it down
Set to 255 with rotating knob and press it down
Set to 255 with rotating knob and press it down
Set to 255 with rotating knob and press it down
Set to 0 with rotating knob and press it down
Leave default setting without any change
Leave default setting without any change
Leave default setting without any change
Leave default setting without any change
Press down the rotating knob to validate settings
GE Multilin