Product Setup; General Overview Of Setpoint Menu In Enervista 650 Setup; General Overview Of Product Setup Menu; Settings Menu Overview - GE Multilin F650 Instruction Manual

4.1 ENERVISTA 650 SETUP SOFTWARE INTERFACE
Table 4–5: GENERAL OVERVIEW OF SETPOINT MENU IN ENERVISTA 650 SETUP:
SETPOINT
4
Options enabled only in On-line mode are marked as (*). Options enabled only in Off-line mode are marked as (**)

4.1.7.1 PRODUCT SETUP

Table 4–6: GENERAL OVERVIEW OF PRODUCT SETUP MENU:
PRODUCT
SETUP
Options enabled only in On-line mode are marked as (*). Options enabled only in Off-line mode are marked as (**)
4-18
Communications settings for all protocols and physical mediums.
Product Setup ModBus user map definition, fault report, oscillography, data logger and
demand settings.
General Settings, Flex Curves Definition, Breaker settings and
System Setup
maintenance, and switchgear snapshot events management.
Phase, Neutral, Ground, Sensitive Ground and Negative Sequence
Protection Elements Current Settings. Voltage Elements settings and Power Settings
management.
Setting groups, under and overfrequency settings, synchrocheck,
Control Elements autoreclose, breaker failure, VT fuse failure, broken conductor and
locked rotor settings management.
Inputs/Outputs Contact I/O settings for all boards available in device, Remote Comms.
Configuration of Outputs, LEDs, Operations, Protection Elements,
Oscillography, Operations, Control Events, Switchgear, Inputs, Virtual
Relay Configuration
Inputs, Operations and HMI. Whole relay configuration with internal relay
signals or user-definable ones as logic (virtual outputs).
Logic configuration graphic editor (PLC Editor). It is a PLC Project file
editor that contains all the internal drawings used to make the logic
Logic Configuration
(virtual outputs) based on IEC 61131-3 standard. Functional block
diagram (FDB).
Relay synchronization to computer clock or to user-definable date and
Clock (*)
time. On-line mode only.
Communication Serial Ports, Network (Ethernet), ModBus Protocol, DNP Slave and IEC
Settings 870-5-104 settings.
ModBus user map definition. The ModBus user map is formed by 256
ModBus User Map
records, selectable from the complete relay ModBus map.
Fault Report Fault report settings. Possibility to show fault reports on HMI screen.
Oscillography settings (trigger position, samples per cycle, etc). The
Oscillography trigger and digital channels (up to 16) must be configured in
"Settings>Relay configuration".
Data Logger Data logger configuration
Demand settings. The demand trigger and demand reset signals must be
Demand
configured in "Settings>Relay configuration"
F650 Digital Bay Controller
4 HUMAN INTERFACES

4.1.7 SETTINGS MENU OVERVIEW

GE Multilin