Example Nº 3 - Procedure To Set An Operation; Description Of The Exercise; Procedure - GE Multilin F650 Instruction Manual

10.3 EXAMPLE Nº 3 – PROCEDURE TO SET AN OPERATION IN THE F650 RELAY
EXAMPLES
10.3EXAMPLE Nº 3 – PROCEDURE TO SET AN OPERATION IN THE F650 RELAY
This simple operation describes how to program and set an operation command on the F650 relay. In the present case the
operation is:
To configure some F650 output contact to be operated since the front of the relay.
To set some LED to show the operation of the output contact (while being closed).
To close a F650 output contact using a front key pushbutton.
To reset the output contact and LED using another front key pushbutton.
Set the following values:
Under
SETPOINT ⇓ CONTROL ELEMENTS ⇒ INPUTS/OUTPUTS ⇒ BOARD F
* This setting is non-relevant since it applies only when "pulse" type is chosen
Under
SETPOINT ⇓ RELAY CONFIGURATION ⇒ OUTPUTS
SELECT
Contact Output Operate 00 (Board F)
£
£ Contact Output Reset 00 (Board F)
Under
SETPOINT ⇓ RELAY CONFIGURATION ⇒ LEDS
10
10-8
NAME
Output Logic_00_00
Output Type_00_00
Pulse Output Time
SELECT NAME
Led 14 Close Contact_00_00
£
F650 Digital Bay Controller

10.3.1 DESCRIPTION OF THE EXERCISE

VALUE
Positive
Latch
10000ms *
NAME
C_Output Oper_00_00
C_Output Reset_00_00
SOURCE
C_Output_00_00
10 APPLICATION

10.3.2 PROCEDURE

SOURCE
Operation_bit000
Operation_bit001
GE Multilin