Oscillography - GE Multilin F650 Instruction Manual

5 SETPOINTS
This menu is used for selecting the digital channels to be included in oscillography records, and the oscillo trigger signal. As
for the above-described setpoints, the trigger selection can be any of the signals provided by the relay or a logic
combination of these.
setpoints are described below:
• Select checkbox enables or disables a digital channel and the oscillography trigger.
• Name setpoint defines the name of the digital channel to be included in oscillography records.
• Source setpoint defines the source or signal to be recorded in that specific channel, which can be selected among all
the operands available in the signals menu.
• NOT checkbox inverts the enabled digital channel signal.
• OR checkbox to select a group of operands instead of a single one. The relay performs an OR of the signals, and its
output produces operation.
NOTE This screen is used for the configuration of digital channels and oscillography trigger. The rest of parameters,
such as function enabling/disabling, sampling rate, number of oscillography files, etc. must be set on the
Setpoint > Product Setup > Oscillography menu.
GE Multilin
Figure 5–46: OSCILLOGRAPHY CONFIGURATION
F650 Digital Bay Controller
5.8 RELAY CONFIGURATION

5.8.5 OSCILLOGRAPHY

5-127
5