MCK pbxgateway Administrator's Manual page 75

Configuration
Synchronous-Serial Device Configuration (RVP_Direct)
Introduction This section of the manual provides the necessary
information to configure the PBXgateway for connection
to a synchronous-serial device. The units are programmed
at the factory with "default" settings providing basic
parameters to accommodate many network environments.
Prerequisites for Configuration
Both units must be installed properly (see Chapter 3) and the network
"
link between both devices must be operational.
Basic Configuration
You must ..........
Set the voice
compression
algorithm for all
active phone ports.
Enable/Disable
WAN ports
Set the Sync Rate of
the WAN port
Set the mode
(interface type)
of the WAN
Configure the Remote
unit.
Increase Jitter (for
Frame Relay installs)
Table 4-3. Basic Configuration Steps
to............ Follow these steps.......
Provide adequate
"
bandwidth for all
"
users.
Enable WAN ports Refer to page 4-32
to connect to
network device.
Match the data rate Refer to page 4-33
(sync rate) of the
network device.
Match the interface Refer to page 4-35
type of the network
device.
Set the required Refer to page 4-54
parameters.
Match network Refer to page 4-20
characteristics.
Issue 2.1 December 1999
Refer to page 4-20
Refer to Appendix B,
Bandwidth
Requirements.
4-14