MCK pbxgateway Administrator's Manual page 118

Configuration
Direct Serial Connection continued
Press the → → → → key to the Primary Interface parameter. This is the main
3.
WAN port (usually WAN1) that connects the Remote unit to the network
device.
Press the → → → → key to scroll through the choices.
4.
Press the ↓ ↓ ↓ ↓ key to the Secondary Interface parameter. This identifies the
5.
secondary WAN port.
Note: This parameter is normally set to None.
Press the ↓ ↓ ↓ ↓ key to the Utilization parameter. This parameter is a numeric
6.
value that represents the percentage of bandwidth used by the remote
unit. See page 5-39 for more information on setting this parameter.
Note: This should be left at 100.
Press the ← ← ← ← key to accept changes and go back to the Configuration
7.
Menu. Press the ↓ ↓ ↓ ↓ key to the Save option. Press Enter.
Issue 2.1 December 1999
4-57