MCK pbxgateway Administrator's Manual page 214

File Management & System Upgrades
Configuration File Management
Changing the Active Config file
Introduction When the PBXgateway is powered-up, the Flash file
system loads a configuration file (called the "active" .rem
(Remote) or .swt (Switch) file) which contains all the
parameters necessary for operation. The system
administrator can change this "active" .rem (Remote) or
.swt (Switch) file so that a different set of parameters
loads.
Note: The default configuration file shipped with the
units is runtime.rem or runtime.swt.
Procedure Access the Config Menu using the following path:
Path: Utilities->Upgrade->
1. Select an existing .rem (Remote) or .swt (Switch) file
from the list displayed.
2. The display reads;
Change Configuration file to..
Enter (Y) or (N).
3. The unit will then prompt you to reboot. This change
requires a reboot in order to take affect.
All changes made to the Switch or Remote parameters
will be saved under the new config file.
Config File
Issue 2.1 December 1999
7-4