MCK pbxgateway Administrator's Manual page 280

Appendix D
SNMP Set up
This Addendum covers information for installing all support software,
accessing and identifying specific trap information, viewing the "Alarm Log"
and walking the MIB.
Set up steps
1. Load a third party-network management software package, such as HP
OpenView, onto the PC used to manage the PBXgateway Switch and
Remote units.
Note: There are many applications that can be used to manage the SNMP
parameters for the Switch and Remote units.
2. Install the EXTender configuration files, available on MCKs web site
(www.mck.com), onto the same PC mentioned in step 1.
3. Add the EXTender's MIB to the third party-network management
software package database. This will allow the software to access the
status and configuration variables of the EXTender.
4. Set the password (Community String) to allow access to the EXTender.
5. Format the Trap error messages from the EXTender into an easily read
form.
6. Enable SNMP within the MI.
Issue 2.1 December 1999
D-16