MCK pbxgateway Administrator's Manual page 45

PBXgateway Installation
3. INSTALLATION
Introduction This Chapter provides the following information for
installing both the Switch and Remote units:
"
"
"
"
Safety Checklist
"
"
"
"
"
"
"
"
"
Pre-installation requirements
How to install the hardware
How to wire the hardware
Complete power-up sequence
!
IMPORTANT SAFETY INSTRUCTIONS
Do not install this product near water, for
example, in a wet basement location.
Do not overload wall outlets, as this can result in
the risk of fire or electrical shock.
Do not attach the power supply cord to building
surfaces.
Do not allow anything to rest on the power cord.
Do not locate this product where the cord will be
damaged by someone walking on it.
Do not operate the system if chemical gas
leakage is suspected in the area. Use telephones
located in some other safe area to report the
trouble.
Never install telephone wiring during a lightning
storm.
Never install telephone jacks in wet locations
unless the jack is specifically designed for wet
locations.
Never touch non-insulated telephone wires or
terminals unless the telephone line has been
disconnected at the network interface.
Issue 2.1 December 1999
3-2