MCK pbxgateway Administrator's Manual page 49

PBXgateway Installation
Customer Supplied Equipment
Note: This includes information for installing the PBXgateway. For
information on "Customer Supplied Equipment" for each Remote unit, refer
to the specific User's Guide.
The customer must supply the following equipment:
Telephones and line cords
"
Note: Use two-wire digital display phones only.
Two 50-pin RJ 21 female connectors for connecting the PBX to the
"
PBXgateway and digital phones to the EXTender 6000.
(Refer to Table 3-2, on page 3-10, for wiring information)
Punch blocks capable of cross connecting the PBXgateway to the PBX
"
and digital phones to the Remote locations.
A PC (or VT-100 compatible terminal) for configuration.
"
One 10baseT RJ-45 cable if connecting the units to the Ethernet network.
"
T1, Fractional T1, ISDN, Frame Relay or ATM circuit at both Remote
"
and Switch locations. Must be capable of connecting the remote branch
office to the Switch location.
A network terminating device capable of interfacing with the
"
PBXgateway and Remote units. Must support synchronous serial
protocol using RS-232, V.35, or RS-530 interface types, or a 10BaseT
Ethernet for an IP connection.
Note: Voice over IP installations have greater circuit flexibility.
PBX digital ports programmed correctly for the telephone type being
"
used at the remote location.
Issue 2.1 December 1999
3-6