MCK pbxgateway Administrator's Manual page 210

Troubleshooting
Remote Phone Messages continued
Message
Connect rejected
Connect Timeout
Network disabled
Network down
Network in use
Network not ready
No bandwidth
Table 6-11. Connect Error Messages
Note: This message is not preceded by "Connect error".
Description
The PBX/KSU rejects
the connection request.
Remote cannot connect
to PBXgateway.
The network device is
not connected, being
used, or is not active.
The network device has
a problem.
The network device is
being used by another
device.
The network device is
not ready for use.
(yellow LED)
The unit bandwidth is
oversubscribed. No
network bandwidth is
available from phone
signaling.
Issue 2.1 December 1999
Action
Possible connect
#
password is
incorrect.
Check network
#
links.
Attempt to
#
reconnect.
Check WAN
connection on
PBXgateway unit.
Check network link and
device.
Check network link and
device.
Reset WAN and try to
re-connect.
Make sure primary
connect matches
"enabled" WAN port.
Check synch rate or
change voice
compression.
6-39