7.3
Looping Scenes
Loop allows you to repeat any number of Scenes (a section of your track). This can be useful
for listening to a section of a track on repeat while composing, or used as a performance tool.
To set a Loop range:
1.
Press
SHIFT
+ right page button (LOOP) to enter Loop Mode.
⇨
The Scene buttons will illuminate.
2.
Press a Scene button (1-8) e.g.
3.
Press a Scene button (1-8) e.g.
⇨
All Scene buttons between
4.
Press
PLAY
to hear the Scenes.
⇨
The Song will play and then repeat in the loop range.
5.
Press
SHIFT
+ right page button (LOOP) to stop the loop.
The loop will continue until it is stopped. The loop range can be altered at any time by
→
repeating the procedure and adding new start and end points.
Press and hold a Scene button then turn the Encoder to set a loop range.
7.4
Setting the Performance Grid
Grid on-screen overlay is used to set quantize values for the following features:
3
to select the start point for the loop.
6
to select the end point for the loop.
3
and
6
illuminate according to the set Loop range.
Arranging your Project
Looping Scenes
MASCHINE JAM - Manual - 117