Native Instruments Maschine Jam Manual page 153

Glossary
Channel Properties
Channel properties are sets of parameters available at each Project level (i.e. for each Sound,
each Group, and for the Master) that are independent of the Plug-ins loaded in that Sound/
Group/Master. Like the Plug-in parameters, in the software the Channel properties are dis-
played in the Control area. For example, the volume, pan or swing controls are properties of
their respective Sound/Group/Master channel.
Clip
Clips are found in the Arranger in form of colored blocks. Clips are the building blocks for
Scenes. A Clip is a reference to a particular Pattern. In one Scene you can create one Clip for
each Group — in other terms, in each Scene you can play one Pattern of each Group. You can
create more than one Clip referencing the same Pattern in different Scenes. When you modify
your Pattern in the Pattern Editor, all Clips referencing this Pattern in the Arranger will get up-
dated accordingly.
Control Area
The Control area is located in the middle of the MASCHINE window, between the Arranger
(above) and the Pattern Editor (below). This area allows you to adjust all Plug-in parameters
and Channel properties for the selected Sound/Group or the Master level: routing, effects, Mac-
ro Controls, etc.
Control Lane
Located at the bottom of the Pattern Editor in the MASCHINE window, the Control Lane shows
and lets you edit the recorded automation in form of automation points for each automated pa-
rameter. You can add, remove, or manipulate existing automation points as well as add new
parameters to automate.
Control Mode
Control mode also allows you to easily adjust any parameter of your channels (Master, Group
and Sound) and any plug-ins contained in them via the Control section of your controller.
MASCHINE JAM - Manual - 153