Clearing Patterns; Duplicating Patterns - Native Instruments Maschine Jam Manual

Instead of holding DUPLICATE, you can also pin the Duplicate Mode by pressing
PLICATE + SONG
Duplicate Mode until you press
and Mode Pinning
6.4.8

Clearing Patterns

You can clear a Pattern from your Project using MASCHINE JAM. When a Pattern is cleared it
is removed from the Scene.
On your controller, do the following to clear a Pattern:
1. Press the SONG button to return to the Project View.
⇨
An overview of your Scenes and Patterns is provided.
2. Press and hold CLEAR.
3. Press the click-pad on the 8x8 click-pad matrix containing the Pattern you want to clear.
The Pattern is removed from the Scene and deleted.
→
If you have more than eight Patterns for a Group, use the up/down arrow of the D-pad to
gain access your all your Patterns.
6.4.9

Duplicating Patterns

You can copy and paste Patterns in your Project within the same Group using MASCHINE JAM.
On your controller in Song Mode, do the following to copy a Pattern from slot to another:
1. Press the SONG button to enter Song Mode.
⇨
An overview of all your Scenes and Patterns is provided.
2. Press and hold DUPLICATE.
3. Press the Pattern button you want to copy.
⇨
The click-pad containing the Pattern starts blinking.
4. Press the click-pad of the target Pattern slot.
[PIN]. You can then release DUPLICATE: Your controller will stay in
DUPLICATE again. See section
for more information.
Recording and Editing Patterns
DU-
↑4.3, Controller Modes
MASCHINE JAM - Manual - 111
Editing a Pattern