Clearing Scenes - Native Instruments Maschine Jam Manual

On your controller in Song Mode, do the following to copy a Scene and all its contents from
slot to another:
1. Press the SONG button to enter Song Mode.
⇨
This will provide an overview of all your Scenes and Patterns.
2. Press and hold DUPLICATE.
3. Press the Scene button (1-8) you want to copy. If your Project contains more than eight
Scenes, press SHIFT
⇨
The button containing the Scene starts blinking.
4. Press the button of the target Scene slot.
An exact duplicate of the Scene is copied. The copied Scene will replace any Scene previ-
→
ously loaded in the target slot.
You will notice that once you have pasted the Scene, the target slot starts blinking itself, indi-
cating that it is ready to be pasted again to additional Scene slots: Therefore, to duplicate a
Scene more than once, after you have pressed the source button you only need to press all the
desired target buttons in a row.
Instead of holding DUPLICATE, you can also pin the Duplicate Mode by pressing
PLICATE + SONG
Duplicate Mode until you press
and Mode Pinning
7.6

Clearing Scenes

You can clear a Scene from your Project using MASCHINE JAM. When a Scene is cleared it is
removed (deleted) from the Project, however, the Patterns still remain available.
On your controller, do the following to clear a Scene:
1. Press the SONG to return to the Project View.
+ Scene button (1-8) to access a Scene bank.
[PIN]. You can then release DUPLICATE: Your controller will stay in
DUPLICATE again. See section
for more information.
Arranging your Project
DU-
↑4.3, Controller Modes
MASCHINE JAM - Manual - 119
Clearing Scenes