Table of Contents
Advertisement
3700 Portable Samplers
Section 3 Programming Guidelines
3.17.3 Reviewing or Printing
Program Information
3-102
If the pump count reaches the number entered for the Tubing
Life Warning setting, the Pump Tubing Warning will be dis-
played. An illustration of the warning is shown below.
WARNING: Replace
The sampler tracks and reports the following items:
• program start time and date
• sample volume
• source of each sample event
• cause of any missed samples
• start time of each sample event
• number of pump counts to liquid detection for each
event
• time the routine was completed
• sampler ID
• current time and date
• program settings
Each of these items is illustrated in Example Reviewing the
Sampling Results.
When you press
DISPLAY STATUS
the pump tubing warning. It allows you to review the program
settings or sampling results.
[REVIEW, PRINT]
PROGRAM INFORMATION
Review – Select "REVIEW" to review the program settings and
sampling results. The sampler will present the display shown
below. Use this display to leave the Display Status procedure or
to review the program settings or sampling results.
REVIEW PROGRAM
SETTINGS, RESULTS]
No – Select "NO" to return to the previous operating state. If you
entered Display Status from standby, the standby message will
reappear. If you entered Display Status from the run state, the
sampling routine will resume.
Settings – Select "SETTINGS" to review the program settings.
Use the left arrow, right arrow, and the
move through the sampling settings. When the right arrow or the
key is pressed at the last settings display, the
/
ENTER
PROGRAM
"REVIEW PROGRAM" display will reappear.
Results – Select "RESULTS" to review the results of the sam-
pling routine. The first display reports the time and date the
sampling program started. Use the
pump tubing!
, the display shown below follows
Display #148
[
,
NO
Display #150
/
ENTER
left and right arrows
keys to
PROGRAM
, and
Advertisement
Table of Contents
