Table of Contents
Advertisement
• If the system was configured with an IP address, access
the system from a network computer by entering
"http://___.___.___.___", where the blanks are replaced by
the selected address.
• If the system was configured for DHCP and a network
name, access the system from a network computer by
entering "http://____________", where the blank is
replaced by the Instrument Name.
The browser window will load PeakTrak after you enter the
address.
Table 4-1 Personal Computer Recommendations
Operating Systems:
Hardware:
Network Protocol:
Network Connection:
Display:
Internet Browser:
a. This table shows supported PC configurations. Other configurations or
AJAX-compatible browsers may be possible but are unsupported by Tele-
dyne Isco.
4.1.2 Network Printing
The CombiFlash R
supports both JetDirect and line printer (LPR) queues.
Consult with your network administrator to determine the IP
address of selected printer. If the printer uses an LPR print
queue, you must also find out the queue name. If the printer
uses a JetDirect print queue, also ask for the port number.
When this information is known, you can proceed with
configuring system for network printing.
1. Select the Tools>Configuration menu command.
2. The Configuration window has two tabs. Select the
Network Configuration tab.
3. Follow the on-screen instructions for entering the address
and queue information.
Microsoft Windows 2000, XP, or Vista
The computer hardware must meet the minimum
required specifications of the selected operating
system.
TCP/IP
IEEE 802.3 (Ethernet)
800 x 600 pixels, 256 colors, minimum
Microsoft Internet Explorer 6.0 or later.
system can print to a network printer and
f
Section 4 Remote Interfaces
a
4-3
Advertisement
Table of Contents
