Table of Contents
Advertisement
3700 Portable Samplers
Section 3 Programming Guidelines
Example: Time-Paced Multiplexed (samples-per-bottle) Sampling
When the final sample has been deposited in the first bottle, the display changes to indicate the new sample bottle.
This display indicates that the upcoming sample event will place the first of four sample volumes in bottle 2 at 7:00.
This display appears as the pump delivers the first sample to bottle 2.
The cycle of displays is repeated for each bottle until the sampling routine is done.
When the routine is completed, this message appears. It reports the status of the routine ("DONE"), the total number
of sample events, and the current time and date.
Example: Extended Flow-Paced Multiplexed (bottles-per-sample)
1. Press
/
ENTER
PROGRAM
2. Access the program sequence by selecting "PROGRAM."
3. Select "FLOW."
3-84
2 OF
4,
2 OF
4,
PUMPING 75 ml
3 OF
4,
AT
6:30
1
OF
AT
7:00
1
OF
DONE . . . 96 SAMPLES
6:10:35
Example Extended Flow-Paced Multiplexed (bottles-per-sample)
Sampling shows how to program the sampler to take samples at
intervals of 10 pulses. Samples will be multiplexed: 800 ml
sample volumes will be placed into two bottles at each sample
event. Each bottle is to receive one sample volume. The routine
will use the start time delay.
Sampling
to access the interactive state.
. . . STANDBY . . .
10:35:23
[
PROGRAM
SAMPLER
[ TIME ,
FLOW
PACED SAMPLING
BOTTLE 1
BOTTLE 1
BOTTLE 1
6:15:27
↓
↓
4,
BOTTLE 2
6:45:25
4,
BOTTLE 2
↓
↓
21-JUN-04
19-JUN-04
, CONFIGURE ]
, STORM ]
Advertisement
Table of Contents
