Load Stored Program - Teledyne 3700 Installation And Operation Manual

3700 Portable Samplers
Appendix D Display Index
Programming Mode configure option. Select "BASIC" to use the basic programming mode. To use the extended pro-
gramming mode, select "EXTENDED."
Display 250
Load Stored Program configure option. Select the sampling program you want to use. Select "NONE" to exit the dis-
play without loading a program.
Display 255
Save Current Program configure option. Select the number with which you want to use to identify the current program
when saved. Select "NONE" to exit the display without saving a program.
Display 260
Flow Mode Sampling configure option. This setting affects flow-paced sampling routines. Select "YES" to take the first
sample at the start time, "NO" to take the first sample at the end of the first flow-pulse interval.
Display 270
Flow Mode Sampling configure option. This setting affects flow-paced, time-switched sampling routines only. Select
"YES" to take a sample at switch times. Select "NO" if you do not want a sample event at the switch times.
Display 271
Nonuniform Time configure option. Select "CLOCK TIME" to enter the nonuniform time intervals as clock times (Dis-
play #26). Select "MINUTES" to set the nonuniform intervals in minutes (Display #27).
Display 280
Calibrate Sampler configure option. Select "ENABLE" to add calibration displays to the program sequence. Select
"DISABLE" to omit the calibration displays.
Display 290
Sampling Stop/Resume configure option. Select "ENABLE" to add the Sampling Stop/Resume settings to the pro-
gram sequence. Select "DISABLE" to omit the settings.
Display 300
Sampling Stop/Resume configure option. This display appears when you select "ENABLE" in Display #300. Select
"YES" to take a sample at stop times. Select "NO" if you do not want a sample event at the stop times.
Display 301
Sampling Stop/Resume configure option. This display appears when you select "ENABLE" in Display #300. Select
"YES" to take a sample at the resume times. Select "NO" if you do not want a sample event at the resume times.
Display 302
Start Time Delay configure option. Enter the amount of time, in minutes, you want to delay the start time. This entry
affects programs that do not have a programmed start time.
Display 310
D-8
Table D-1 Display Index (Continued)
[BASIC, EXTENDED]
PROGRAMMING MODE
LOAD PROGRAM
[ #1 , #2 , #3 , NONE ]
SAVE PROGRAM AS
[ #1 , #2 , #3 , NONE ]
TAKE SAMPLE AT START
TIME? [ YES , NO ]
TAKE SAMPLE AT TIME
SWITCH? [ YES , NO ]
ENTER INTERVALS IN
[ CLOCK TIME , MINUTES ]
[ ENABLE, DISABLE ]
CALIBRATE SAMPLE
[ ENABLE, DISABLE ]
SAMPLING STOP/RESUME
SAMPLE AT STOP?
[ YES , NO ]
SAMPLE AT RESUME?
[ YES , NO ]
---- MINUTE DELAY
( 0 - 9999 )
TO START