Parameter Lists - Danfoss vlt fc 300 Instruction Manual

VLT
How to Program
Instruction Manual High Power

4.3 Parameter Lists

Changes during operation
"TRUE" means that the parameter can be changed while
the adjustable frequency drive is in operation and "FALSE"
means that it must be stopped before a change can be
made.
4 4
4-Set-up
Conv. index 100 67 6 5
Conv. factor 1 1/60 1,000,00 100,000 10,000
0
Table 4.3
Data Description
type
2 Integer 8
3 Integer 16
4 Integer 32
5 Unsigned 8
6 Unsigned 16
7 Unsigned 32
9 Visible String
33 Normalized value 2 bytes
35 Bit sequence of 16 Boolean variables
54 Time difference w/o date
Table 4.4
® AutomationDrive FC 300 Design Guide,
See the VLT
MG33BXYY for further information about data types 33, 35
and 54.
4-6 MG34Q222 - VLT
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20872-Danfoss-131H4490-VLT-Automation-VT-Drive-VFD-FC302-460V-25-HP.aspx
®
Automation Drive FC 300 12-Pulse
'All set-up': the parameters can be set individually in each
of the four set-ups, i.e., one single parameter can have four
different data values.
'1 set-up': the data value will be the same in all set-ups.
Conversion index
This number refers to a conversion figure used when
writing or reading to and from the adjustable frequency
drive.
4 3 2 1 0 -1 -2 -3 -4
1,000 100 10 1 0.1 0.01 0.001 0.0001 0.00001 0.000001
Type
Int8
Int16
Int32
Uint8
Uint16
Uint32
VisStr
N2
V2
TimD
® is a registered Danfoss trademark
-5 -6