Using Ac Power And Charging The Battery - FujiFilm SonoSite M-Turbo User Manual

Figure 3 Install the Battery
2 Preparing the system
To install the battery
1 Disconnect the power supply from the
2 Remove the system from the mini‐dock (if
3 Place the battery into the battery
4 Slide the battery forward until it locks into
5 Push down on the two locking levers to secure
Locking
To remove the battery
1 Disconnect the power supply from the
2 Remove the system from the mini‐dock (if
3 Pull up the two locking levers.
4 Slide the battery back.
5 Lift the battery from the compartment.
Using AC power and charging the
battery
The battery charges when the system is
connected to the AC power supply. A fully
discharged battery recharges in less than five
hours.
When using AC power, position the system to allow
easy access to disconnect it.
To separate the system (and any connected
equipment) from a supply mains
Note: Disconnecting only the DC power cable from the
system or dock does not separate the system from the
supply mains.

ultrasound system.
present) and turn it upside down.
compartment, at a slight angle. See Figure
place.
the battery.
ultrasound system.
present) and turn it upside down.
Disconnect the AC power cord from the power
supply or (alternatively, if using a stand) from the
AC adapter on the stand base.
3.