General Calculations; Calculations Menu; Performing And Saving Measurements In Calculations - FujiFilm SonoSite M-Turbo User Manual

• Mean Pressure Gradient (PGmean)
• Mean Velocity on Peak Trace (Vmean)
• Pressure Gradient (PGmax)
• Cardiac Output (CO)
• Peak Systolic Velocity (PSV)
• Time Average Mean (TAM)*
• +/× or Systolic/Diastolic (S/D)
• Pulsatility Index (PI)
• End Diastolic Velocity (EDV)
• Acceleration Time (AT)
• Resistive Index (RI)
• Time Average Peak (TAP)
• Gate Depth

General calculations

Within calculations, you can save measurement
results to the patient report. You can display,
repeat, and delete measurements from a
calculation. Some measurements can be deleted
directly from the patient report pages. See
"Patient report" on page 77.
Calculation packages depend on exam type and
transducer.

Calculations menu

The calculations menu contains measurements
available for the imaging mode and exam type.
After you perform and save a measurement, the
result saves to the patient report. (See "Patient
report" on page 77.) Also, a check mark appears
next to the measurement name in the calculations
menu. If you highlight the checked measurement
name, the results appear below the menu. If you
repeat the measurement, the results below the
menu reflect either the last measurement or the
average, depending on the measurement.
Menu items followed by ellipses (. . .) have
sub‐entries.
To select from the calculations menu
1 On a frozen image, press the
The calculations menu appears.
2 Using the touchpad or arrow keys, highlight
the desired measurement name.
To display additional measurement names,
highlight Next, Prev, or a measurement name
that has ellipses (. . .). Then press the
key.
Only measurement names available for the
imaging mode are selectable.
3 Press the key.
SELECT
To close the calculations menu, press the
key once (if the menu is active) or twice (if the
menu is inactive).
Performing and saving measurements
in calculations
In performing a measurement within a
calculation, you select from the calculations
menu, position the calipers that appear, and then
save the calculation. Unlike measurements
performed outside a calculation, the calipers
appear by selecting from the calculations menu,
not by pressing the
CALIPER
calipers that appear depends on the
measurement.
To save a calculation

Do one of the following:
• Save the calculation only: Press the
key, or select Save on‐screen.
SAVE CALC
The calculation saves to the patient report.
To save the image with the measurements
displayed, see "To save an image" on
page 42.
• Save both the image and calculation: Press
the key if the
SAVE
Chapter 4: Measurements and Calculations
key.
CALCS
SELECT
CALCS
key. The type of
key functionality
SAVE
51