Printer; Battery Charging; Video Output - FujiFilm SonoSite EDGE II Service Manual

Printer

The printer test is an optional test that requires a video printer and Mini-Dock to be connected to the system
under test. Skip this test if a printer is not available.
Test Printer 1
Operation
2
3
4
5

Battery Charging

Test Battery 1
Charging
2
Operation
3
4

Video Output

The video output test is an optional test that requires an external video monitor to be connected to the
system under test. Skip this test if an external monitor is not available.
Test Video 1
Output
2
3
68 Chapter 8: Performance Testing
Connect the Mini-Dock to the system under test.
Connect a video output and print control cable from theMini-Dock to the printer.
Verify proper printer type is configured in the system Settings page.
Tap the print button and verify that the printer begins to print an image. After the image
begins to emerge from the printer, tap the print button again. The printer should ignore
the second print command.
Verify the proper content of the printed image.
Remove the AC power cord and insert a battery into the system.
Press the Power button to turn the system on. Allow the battery to discharge. The
battery indicator icon on the display, below the Transducer Type indicator, will
extinguish from right to left as the battery discharges.
Note: The Power and Sleep delays in the Setup page should be selected to "Off" to
properly perform this test. The battery may take 1–2 hours to discharge.
Reattach the AC power cord to the power connector and power the system on.
Note that the battery indicator indicates that the battery is charging. The sections of
the battery indicator will light sequentially from left to right as the battery charges.
Connect the Mini-Dock to the system under test.
Connect the video output on the Mini-Dock to an external video monitor.
Turn on the system power and verify that the video on the external monitor matches
the video on the system display.
If the video does not appear similar, or there is no display on the external monitor, see
Chapter 5, "Troubleshooting" for troubleshooting procedures.