Fog Lamp Switch Test Export; Fog Lamp Switch Test; Fuel Tank Sending Unit Test; Headlamp Leveling Switch - Chrysler neon 1997 Service Manual

PL
DIAGNOSIS AND TESTING (Continued)

FOG LAMP SWITCH TEST

(1) Remove the fog lamp switch. Refer to the Rear
Window Defogger and/or Fog Lamp Switch Removal.
(2) Using two jumper wires, connect Pin 2 and Pin
4 of the switch to battery voltage.
(3) Using a test lamp, connect the test lamp to Pin
3 as shown in (Fig. 3). Refer to (Fig. 4) for fog lamp
switch circuit.
(4) Push the fog lamp switch button. The test lamp BEAM SEL SW BATTERY TEST LAMP LAMP
LOW BEAM FEED FROM
1/PNL ILLUM FEED
and the LED indicator on the front of the switch
should illuminate.
(5) If either the LED or the test lamp fails to illu-
minate, replace the switch.
Fig. 3 Fog Lamp Switch Test
Fig. 4 Fog Lamp Switch Circuit

FOG LAMP SWITCH TEST EXPORT

Refer to Group 8W, Wiring Diagrams for wiring or
circuit information.
FRONT EXPORT
(1) Remove the fog lamp switch and disconnect the
connector at the center stack.
(2) Using two jumper wires connect Pin L7 to bat-
tery voltage, and connect Pin Z03 to ground (Fig. 5).
CIR- C UIT LOGIC N.O. L.E.D. BATTERY FOG LAMPS
ON/OFF
INSTRUMENT PANEL AND SYSTEMS
(3) Push the fog lamp switch button. The LED
indicator on the front of the switch should illuminate.
Check Pin L35 with a test lamp for battery voltage.
(4) If either the LED or the test lamp fails to illu-
minate, replace the switch.
TEST LAMP BATTERY
Fig. 5 Front Fog Lamp Switch Circuit Diagram
REAR EXPORT
(1) Remove the fog lamp switch. Refer to Rear
Window Defogger and/or Fog Lamp Switch Removal.
(2) Using two jumper wires connect Pin 2 and Pin
4 of the switch to battery voltage.
(3) Using a test lamp, connect the test lamp to Pin
3 as shown in (Fig. 6). Refer to Group 8W, Wiring
Diagrams for fog lamp switch circuit.
(4) Push the fog lamp switch button. The test lamp
should illuminate, and the LED indicator on the
front of the switch.
(5) If either the LED, or the test lamp fails to illu-
minate, replace the switch.
Fig. 6 Rear Fog Lamp Switch Test

FUEL TANK SENDING UNIT TEST

Refer to Group 14, Fuel for test procedures.

HEADLAMP LEVELING SWITCH

(1) Remove the headlamp leveling switch from the
instrument panel and disconnect the wire harness
connector from the switch. Refer to Wiring Diagrams
for the proper wire circuits and the wire connector
connections.
8E - 3