Chrysler neon 1997 Service Manual page 544

CHANNEL FOR LEVEL SEN- REAR VIEW OF LEVEL SEN- SOR WIRE SOR CHANNEL FOR LEVEL SEN- MINAL TER-
PL
REMOVAL AND INSTALLATION (Continued)
(4) Push level sensor signal and ground terminals
out of the connector (Fig. 25).
Fig. 25 Removing Wires From Connector
(5) Insert a screwdriver between the fuel pump
module and the top of the level sensor housing (Fig.
26). Push level sensor down slightly.
Fig. 26 Loosening Level Sensor
(6) Slide level sensor wires through opening fuel
pump module (Fig. 27).
Fig. 27 Level Sensor Removal/Installation
SOR LOCKING WRAP FINGER LEVEL SENSOR FUEL LEVEL SEN- WIRES GROOVE IN SOR FUEL LINE QUICK CONNECTS
FUEL SUP-
PLY LINE
(7) Slide level sensor out of installation channel in
module.
INSTALLATION
(1) Insert level sensor wires into bottom of opening
in module.
(2) Wrap wires into groove in back of level sensor
(Fig. 26).
(3) While feeding wires into guide grooves, slide
level sensor up into channel until it snaps into place
(Fig. 27). Ensure tab at bottom of sensor locks in
place.
(4) Install level sensor wires in connector. Push
the wires up through the connector and then pull
them down until they lock in place. Ensure signal
and ground wires are installed in the correct posi-
tion.
(5) Install locking wedge on connector.
(6) Push connector up into bottom of fuel pump
module electrical connector.
(7) Install fuel pump module. Refer to Fuel Pump
Module in this section.
FUEL INJECTORS
REMOVAL
(1) Disconnect negative cable from battery.
(2) Release fuel system pressure. Refer to Fuel
System Pressure Release procedure in this section.
(3) Disconnect fuel supply tube from rail. Refer to
Quick-Connect Fittings in the Fuel Delivery section
of this group.
(4) Disconnect electrical connectors from fuel injec-
tors (Fig. 28).
Fig. 28 Fuel Rail and Injectors
INJECTOR FUEL IGNITION C OIL
FUEL RAIL
FUEL SYSTEM 14 - 15