Chrysler neon 1997 Service Manual page 404

MOTOR MOUNTING SCREWS
PL
REMOVAL AND INSTALLATION (Continued)
WARNING: FAILURE TO CLAMP THE SECTOR
GEAR TO THE MOUNTING PLATE WHEN REMOV-
ING THE MOTOR CAN RESULT IN INJURY.
(3) Secure the sector gear and mounting plate with
a C clamp or similar clamping tool. This will prevent
a sudden and forceful movement of the regulator
when the motor is removed.
(4) Remove three mounting screws that hold motor
gearbox to regulator (Fig. 5).
(5) Remove motor from regulator.
Fig. 5 2 Door Motor Removal
INSTALLATION
(1) Install new motor on regulator by positioning
motor gearbox so that it engages regulator sector
teeth.
(2) A slight rotational or rocking movement may
be necessary to bring three motor gearbox screw
holes into proper position.
(3) Install three gearbox screws and one tie down
bracket screw, if applicable. Tighten to 5.6 to 8 N·m
(50 to 70 in. lbs.) torque.
(4) Install regulator, using the switch, test opera-
tion of motor.
CLAMP REGULATOR SECTOR GEAR TO
4 DOOR WINDOW MOTOR
REMOVAL
CABLE DRUM
(1) Move the window so it is not in the full up or
down position, if possible.
(2) Remove door trim panel, refer to Group 23
Body for removal procedures.
(3) Disconnect wiring connector from motor.
(4) Remove the three nuts attaching the window
regulator motor/housing to the door inner panel. This
will allow the motor/housing to be moved to the lower
door inner panel opening since the cables will flex
(Fig. 6).
(5) Turn the motor/housing to gain access to the
three nuts attaching the motor to the housing.
(6) Remove the three nuts attaching the motor to
the housing.
(7) Remove the motor from the housing. Be careful
not to pull the cable drum from the housing, as the
motor shaft will tend to pull the drum with it.
Fig. 6 4 Door Motor Removal
INSTALLATION
For installation, reverse above procedures.
POWER WINDOWS
MOTOR
8S - 3