Chrysler neon 1997 Service Manual page 160

DIAGNOSTIC LEFT PANEL CAB CONNECTOR INSTRUMENT MOUNTING BRACKET RETAININGBOLT
PL
REMOVAL AND INSTALLATION (Continued)
CONTROLLER ANTILOCK BRAKES (CAB)
The CAB is mounted under the instrument panel
on the drivers side kick panel of the vehicle (Fig. 27).
Fig. 27 Location Of Controller Antilock Brake (CAB)
REMOVE
(1) Turn vehicle ignition off.
(2) Disconnect the wiring harness 60 way connec-
tor (Fig. 28) from the Controller Antilock Brake Mod-
ule (CAB). VERIFY
IGNITION IS OFF BEFORE REMOVING THE 60
WAY CONNECTOR.
Fig. 28 CAB 60-Way Wiring Harness Connector
(3) Remove the 2 controller bracket to drivers side
cowl mounting nuts (Fig. 29).
(4) Remove the CAB from the vehicle.
60-WAY ANTILOCK CONTROLLER 60–WAY BRAKES NECTOR NECTOR CON-
THAT THE VEHICLE
CON-
Fig. 29 CAB Bracket To Kick Panel Mounting
INSTALL
(1) Install CAB and mounting bracket on mount-
ing studs located on passenger side kick panel (Fig.
29).
(2) Install the 2 CAB bracket mounting nuts (Fig.
29) and securely tighten.
(3) Install the 60-way wiring harness connector
(Fig. 28) by hand into the 60-way CAB connector, as
far as possible. Then use the CAB connector retain-
ing bolt (Fig. 28) to fully seat wiring harness connec-
tor into the CAB.
(4) Torque the 60-way connector retaining bolt
(Fig. 28) to 4 N·m (38 in. lbs.).
(5) If a new CAB is being installed, it must be
initiallized prior to the vehicle being driven.
The CAB is initialized using the DRB Scan Tool
and the initializing procedure described upon
selecting Bendix ABX-4 Diagnostics. New con-
trollers are programmed to flash the ABS warn-
ing lamp until initilized by the installing
technician.
FRONT WHEEL SPEED SENSOR
NOTE: Proper installation of the Wheel Speed Sen-
sor Cables is critical to continued system opera-
tion. Be sure that cables are installed, routed and
clipped properly. Failure to install speed sensor
cables as shown in the on car service section of
this manual, may result in contact with moving
parts or over extension of cables, resulting in an
open circuit.
MOUNTING STUDS (2) MOUNTING NUTS CAB BRACKET
BRAKES 5 - 83