Chrysler neon 1997 Service Manual page 408

PL
DIAGNOSIS AND TESTING (Continued)
(3) Disconnect wire connector.
(4) Using two jumper wires, one connected to a 12
volt source, and 2 the other connected to a good body
ground. Refer to the Mirror Test (Fig. 5) for appropri-
ate mirror response. RHD vehicle with Power Fold TERMINAL END VIEW
Away Mirror refer to (Fig. 6)
(5) If test results are not obtained as shown in the
(Fig. 5), check for open or shorted circuit (Fig. 7), or
replace mirror assembly as necessary.
Fig. 5 Mirror Test
MIRROR MIRROR RELAY CONNEC- MIRROR TOR IN DOOR HARNESS TERMINAL ENDS VIEWS SWITCH CONNECTOR CONNECTORS DOOR(S) WIRING IN
Fig. 6 Power Fold Away Mirror Test
POWER MIRRORS 8T - 3