Chrysler neon 1997 Service Manual page 571

AIR INLET TUBE BATTERY TRAY BATTERY
ELECTRICAL CON-
NECTOR
14 - 42 FUEL SYSTEM
DIAGNOSIS AND TESTING (Continued)
(23) Inspect the fuel pump module electrical connec-
tion at the fuel tank for corrosion or damage (Fig. 51).
Check for pinched, kinked or damaged fuel supply tube.
Fig. 51 Fuel Pump Module Electrical Connector
(24) Inspect the connections to the speed control
servo, if equipped (Fig. 31). Refer to Group 8H, Vehi-
cle Speed Control.
Fig. 52 Battery Temp. Sensor Connectors
(25) Inspect the connection at the battery temper-
ature sensor (Fig. 52).
VISUAL INSPECTION—DOHC
Before diagnosing or servicing the fuel injection
system, perform a visual inspection for loose, discon-
nected, or misrouted wires and hoses (Fig. 53). A
thorough visual inspection that includes the following
checks saves unnecessary test and diagnostic time.
(1) Inspect the battery connections. Clean corroded
terminals (Fig. 31).
TEMPERATURE SENSOR FUEL LINE BATTERY POWER TRIBUTION
Fig. 53 2.0L DOHC Engine Compartment
(2) Check the 2 PCM 40-way connector for
stretched wires on pushed out terminals (Fig. 54).
Fig. 54 Battery, PCM, and PDC
BUTION POWER DISTRI- CEN- TER RELAYS
(3) Open the Power Distribution Center (PDC). Check
for blown fuses. Ensure the relays and fuses are fully
seated in the PDC (Fig. 55). A label on the underside of
the PDC cover shows the locations of each relay and fuse.
Fig. 55 Power Distribution Center
CENTER DIS- WASHER WINDSHIELD SPEED PCM CONTROL BOTTLE SERVO FLUID
FUSES
PL