Chrysler neon 1997 Service Manual page 480

SIDESHIELD SCREW(3)
PL
REMOVAL AND INSTALLATION (Continued)
TIMING BELT COVER
REMOVAL
CAUTION: Camshaft or crankshaft should not be
rotated after timing belt is removed. Damage to
valve components may occur. Always align timing
marks before removing timing belt.
(1) Remove accessory drive belts. Refer to Group 7,
Cooling System for procedure outlined in that sec-
tion.
(2) Raise vehicle on a hoist and remove right inner
splash shield (Fig. 38).
Fig. 38 Right Inner Splash Shield
(3) Remove crankshaft
damper using Special Tool 1026 and Insert 6827–A or
equivalent (Fig. 39).
(4) Lower vehicle and place a jack under engine
(5) Remove right engine mount. Refer to procedure
outlined in this section
(6) Remove right engine mount bracket (Fig. 40)
(7) Remove timing belt cover fasteners, remove
cover (Fig. 40).
RIGHT FRAME SHIELD PLUG RAIL
damper bolt. Remove
SPECIAL CHANNEL TAB SPECIAL TOOL 1026 FASTENERS RETAINER TOOL AND INSERT 6827–A FRONT TIMING BELT COVER FASTEN-
Fig. 39 Crankshaft Damper—Removal
Fig. 40 Front Timing Belt Cover
INSTALLATION
(1) Install front timing cover.
(2) Install engine mount bracket.
(3) Install Right engine mount. Refer to procedure
outlined in this section for installation.
(4) Remove jack from under engine.
(5) Install crankshaft vibration damper Refer to
procedure outlined in this section for installation.
(6) Install accessory drive belts. Refer to Group 7,
Cooling System, Accessory Drive section for proce-
dure.
(7) Raise vehicle on hoist and install right inner
splash shield.
ERS COVER INSPECTION TIMING MOUNT ENGINE BRACKET
2.0L DOHC ENGINE
TENER BELT FAS-
9 - 67