Chrysler neon 1997 Service Manual page 636

PL
REMOVAL AND INSTALLATION (Continued)
(3) Remove power steering pressure hose from
routing clip on generator shield (Fig. 4).
Fig. 4 Power Steering Pressure Hose Routing
(4) Lower vehicle.
(5) Remove bolt, attaching power steering pressure
hose routing clip, to generator shield (Fig. 5).
Fig. 5 Power Steering Hose Attachment To
Generator Shield
(6) Remove Banjo bolt, and power steering pres-
sure hose from pressure fitting on power steering
pump (Fig. 6).
(7) Power steering fluid pressure hose is removed
from the vehicle from the top of the engine compart-
ment.
(8) Discard all used O-rings located at ends of
power steering pressure hose and Banjo bolt.
Fig. 6 Pressure Hose Attachment To Power Steering
INSTALL
(1) Install power steering pressure hose in vehicle
from top of engine compartment.
(2) Using a lint free towel, wipe clean all open
power steering hose ends, and the power steering
pump and steering gear ports.
(3) Install new O-ring on end of power steering
pressure hose banjo fitting (Fig. 7).
Fig. 7 O-ring Installed On Power Steering Hose
Banjo Fitting
STEERING
Pump
19 - 3