Chrysler neon 1997 Service Manual page 37

DISC BRAKE CALIPER DISC STEERING KNUCKLE PER ASSEMBLY BRAKE ASSEMBLY CALI- BRAKING DISC
DISC LIFT THIS END OF BRAKE CALIPER
ATTACHING BOLTS
CALIPER AWAY
FROM STEERING
2 - 26 SUSPENSION
KNUCKLE FIRST
REMOVAL AND INSTALLATION (Continued)
(2) Remove the front wheel and tire.
(3) Remove the 2 bolts (Fig. 52) attaching the disc
brake caliper to the steering knuckle .
Fig. 52 Caliper Attaching Bolts
(4) Remove the disc brake caliper from the steer-
ing knuckle. Caliper is removed by first lifting bot-
tom of caliper away from steering knuckle, and then
removing top of caliper out from under steering
knuckle (Fig. 53).
Fig. 53 Brake Caliper Removal
(5) Support the disc brake caliper using a wire
hook, (Fig. 54) not by the hydraulic flex hose.
(6) Remove the rotor from the front hub (Fig. 55).
(7) Install a lug nut on the wheel stud being
removed from the hub/bearing, so threads on stud
are even with end of lug nut (Fig. 56). Rotate hub so
stud requiring removal is aligned with notch cast
into front of steering knuckle. Install Remover, Spe-
cial Tool C-4150 on hub/bearing flange and wheel
stud (Fig. 56).
DRIVE SHAFT SLIDE THIS END OF CALIPER FROM BRAKING DISC UNDER STEERING KNUCKLE LOWER TROL ARM CON- WHEEL DISC WIRE HANGER DISC BRAKE CALIPER SPECIAL TOOL C-4150A STEERING KNUCKLE STEERING KNUCKLE BRAKE MOUNTING HUB/BEARING WHEEL STUD ASSEMBLY (STORED) LUG NUT
Fig. 54 Correctly Supported Brake Caliper
Fig. 55 Remove/Install Rotor
Fig. 56 Removing Wheel Stud From Hub/Bearing
CALIPER ROTOR HOLE STUD BRAKE HYDRAULIC HOSE STEERING KNUCKLE BRAKE DISC
PL