Chrysler neon 1997 Service Manual page 113

PARK BRAKE LEVER BRAKE SHOE ASSEMBLY PARK BRAKE LEVER PIN
5 - 36 BRAKES
REMOVAL AND INSTALLATION (Continued)
(2) Assemble front and rear brake shoe assembly,
automatic adjuster screw and upper return spring
before installation on brake support plate.
(3) Install the pre-assembled brake shoes, auto-
matic adjuster screw and upper return spring on the
brake support plate (Fig. 86).
(4) Install the wave washer on the pin of park
brake lever.
(5) Install pin on park brake lever into hole in rear
brake shoe assembly (Fig. 89).
Fig. 89 Park Brake Lever Pin Retaining Clip
Installation
(6) Install both brake shoe, to brake support plate,
hold down pins and clips (Fig. 83).
(7) Install the lower brake shoe to anchor plate
return spring (Fig. 84).
(8) Install the automatic adjustment lever, on the
front brake shoe of the rear wheel brake assembly
(Fig. 82).
(9) Install the automatic adjustment lever to front
brake shoe assembly spring (Fig. 81).
(10) Adjust brake shoes assemblies so as not to
interfere with brake drum installation.
(11) Install the rear brake drums on the hubs.
(12) Adjust rear brake shoes per Adjusting Rear
Brakes procedure in the service adjustments section
of the service manual.
(13) Install the wheel and tire assembly.
(14) Tighten the wheel mounting stud nuts in
proper sequence until all nuts are torqued to half
specification. Then repeat the tightening sequence to
the full specified torque of 135 N·m (100 ft. lbs.).
(15) Road test vehicle. The automatic adjuster
will continue the brake adjustment during the road
test of the vehicle.
RETAINING CLIP SCREWDRIVER HUB/BEARING ASSEMBLY HUB/BEARING ASSEMBLY RETAINING NUT
REAR BRAKE SHOE SUPPORT PLATE
REMOVE
(1) Raise vehicle on jackstands or centered on a
hoist. See Hoisting in the Lubrication and Mainte-
nance section of this manual.
(2) Remove rear tire and wheel assembly from
vehicle.
(3) Remove the dust cap (Fig. 90) from the rear
hub/ bearing.
(4) Remove the retaining nut (Fig. 91) holding the
rear hub/bearing to the spindle. Remove the hub/
bearing from the spindle.
Fig. 91 Rear Hub/ Bearing Retaining Nut
DUST CAP SPINDLE
Fig. 90 Hub/ Bearing Dust Cap
PL