Chrysler neon 1997 Service Manual page 580

CABLE
PL
REMOVAL AND INSTALLATION (Continued)
Fig. 86 Disconnecting Throttle Cable
(3) Compress the retaining tabs on the cable and
slide cable out of bracket (Fig. 86).
(4) If equipped with speed control, remove speed
control cable from throttle lever by sliding clasp out
hole used for throttle cable.
(5) Remove 2 screws holding cable mounting
bracket and support bracket.
(6) Remove TPS connector.
(7) Remove Idle Air Control motor connector.
(8) Remove the EVAP purge hose.
(9) Remove throttle body mounting bolts. Remove
throttle body.
(10) The rubber O-ring gasket on the intake man-
ifold is reusable. Wipe the O-ring clean before install-
ing throttle body (Fig. 91).
INSTALLATION
(1) Install throttle body on intake manifold.
Tighten mounting bolts.
(2) Attach cable mounting bracket and support
bracket with 2 screws.
(3) Connect the electrical connetion to the throttle
body.
(4) Connect the EVAP purge hose to the throttle
body.
(5) Install cable housing(s) retainer tabs into
bracket.
(6) If equipped with speed control, rotate the throt-
tle lever forward to the wide open position and
install speed control cable clasp (Fig. 86).
(7) Rotate throttle lever to wide open position and
install throttle cable clasp (Fig. 86).
(8) Install throttle cable cover. Tighten bolt to 5.6
N·m (50 ins. lbs.).
THROTTLE BODY—AUTOMATIC TRANSMISSION
REMOVAL
(1) Remove throttle cable cover.
TABS
CLASP
SPEED TROL CABLE CON- CABLE CLASP
(2) Remove throttle body cables using the following
procedures.
(3) Remove throttle cable from throttle body cam
(Fig. 87) and (Fig. 88).
Fig. 87 Throttle Body Cables Attachment to Throttle
Fig. 88 Disconnecting Throttle Cable
(4) Compress the retaining tabs on the cable and
slide cable out of bracket (Fig. 88).
(5) Hold throttle lever in the wide open position.
Using finger pressure only, remove kickdown cable by
PUSHING connector off the lever nail head (Fig. 87)
and (Fig. 89). DO NOT try to pull connector off per-
pendicular to the lever.
(6) Compress the retaining tabs on the cable and
slide cable out of bracket (Fig. 88).
(7) if equipped with speed control, hold throttle
lever in the wide open position. Using finger pressure
only, remove speed control cable by PUSHING con-
nector off the lever nail head (Fig. 87) and (Fig. 90).
DO NOT try to pull connector off perpendicular to
the lever.
THROTTLE CABLE TRANSMISSION KICKDOWN CABLE TABS
FUEL SYSTEM
Body
14 - 51