Chrysler neon 1997 Service Manual page 130

PARK BRAKE CABLE SCREW DRIVER ROUTING BRACKET RETAINER FUEL FILTER PARK
STONE SHIELD
PL
REMOVAL AND INSTALLATION (Continued)
(21) On vehicles equipped with rear disc brakes,
remove park brake cable (Fig. 151) from rear disc
brake adapter. Park brake cable is removed from disc
brake adapter using a screwdriver as shown in (Fig.
151) to compress locking tabs on park brake cable
retainer.
Fig. 151 Park Brake Cable Removal From Disc
Brake Adapter
(22) Remove park brake cable routing bracket (Fig.
152) from vehicle frame rail.
Fig. 152 Park Brake Cable Routing Bracket
(23) Remove park brake cable and sealing grom-
met (Fig. 153) from floor pan of vehicle.
INSTALL
(1) Install park brake cable into floor pan of vehi-
cle making sure sealing grommet is installed in floor
pan as far as possible to insure proper seal.
(2) Install park brake cable into brake support
plate or rear disc brake adapter. Be sure locking tabs
on cable retainer are expanded to ensure park brake
cable is securely held in support plate or adapter.
BRAKE CABLE TENSION STRUT DISC FRAME RAIL ADAPTER BRAKE
PARK BRAKE CABLE
FUEL TANK SEALING GROM- MET
Fig. 153 Park Brake Cable Seal At Floor Pan
(3) Install park brake cable routing bracket (Fig.
152) on frame rail. Install and securely tighten rout-
ing bracket attaching bolt.
(4) On vehicles equipped with rear drum
brakes, install park brake cable on park brake cable
actuating lever (Fig. 146). Then install actuating
spring between brake shoe assembly and brake
adjustment lever (Fig. 147).
(5) On vehicles equipped with rear disc
brakes, install park brake shoes actuator lever (Fig.
149) on park brake cable. Then install park brake
shoe assemblies on disc brake adapter (Fig. 148).
(6) Install the hub/bearing assembly on the rear
spindle. Then install A NEW rear hub/bearing
assembly retaining nut. Torque hub/bearing assembly
retaining nut to 217 N·m (160 ft. lbs.).
(7) Install hub/bearing assembly dust cap, using a
soft faced hammer.
(8) On drum brake equipped vehicles, install rear
brake drum on hub/bearing assembly. On vehicles
equipped with rear disc brakes, install rotor on hub/
bearing assembly.
(9) On disc brake equipped vehicles install disc
brake caliper on disc brake adapter. Install the 2 cal-
iper guide pin bolts (Fig. 154) and torque to 22 N·m
(192 in. lbs.). Refer To Rear Disc Brake Service in
this group of the service manual for the required cal-
iper installation procedure.
(10) Install rear wheel and tire assembly on vehi-
cle. Tighten all wheel stud nuts in criss cross pattern
to one-half specified torque. Then repeat pattern,
fully tightening stud nuts to 135 N·m (100 ft. lbs.).
(11) Lower vehicle.
(12) Grasp park brake cable to floor pan seal
grommet (Fig. 155) by hand, and pull it into floor
pan to ensure seal grommet is fully seated into floor
pan.
(13) Route park brake cable under carpeting and
up to park brake cable retaining bracket on floor
PARK BRAKE CABLE FLOOR PAN
BRAKES 5 - 53