Chrysler neon 1997 Service Manual page 352

PARK AND TURN SIGNAL LAMP BULB
PL
REMOVAL AND INSTALLATION (Continued)
Fig. 3 Park and Turn Signal Lamp Bulb
FRONT SIDE MARKER LAMP BULB
REMOVAL
(1) Reach behind front bumper fascia forward of
front wheel.
(2) Remove socket from side marker lamp.
(3) Pull bulb from socket (Fig. 4).
Fig. 4 Front Side Marker
INSTALLATION
Reverse the preceding operation.
CENTER HIGH MOUNTED STOP LAMP BULB
REMOVAL
(1) Release trunk latch and open trunk lid.
(2) Remove bulb socket from center high mounted
stop lamp (Fig. 5).
(3) Pull bulb from socket.
INSTALLATION
Reverse the preceding operation.
SIDE MARKER LAMP SOCKET FRONT BUMPER FASCIA BULB SOCKET REAR CLOSURE SOCKET PANEL CENTER BULB HIGH STOP LAMP MOUNTED
Fig. 5 CHMSL Bulb
TAIL, STOP, BACK-UP AND TURN SIGNAL LAMP
BULB
REMOVAL
(1) Release trunk latch and open trunk lid.
(2) Separate trunk lining from rear closure panel
to gain access to back of tail lamp.
(3) Rotate and remove bulb socket from tail lamp
through openings in rear closure panel (Fig. 6).
(4) Pull bulb from socket.
Fig. 6 Tail and Stop Lamp Bulb
INSTALLATION
(1) Push bulb into socket.
(2) Rotate and install bulb socket into tail lamp
through openings in rear closure panel.
(3) Install trunk lining to rear closure panel.
(4) Close and secure trunk lid.
TAIL LAMP BULB SOCKET
LAMPS 8L - 9