Wiper Linkage; Wiper Module; Wiper Motor; Wiper Switch - Chrysler neon 1997 Service Manual

8K - 6 WINDSHIELD WIPERS AND WASHERS
REMOVAL AND INSTALLATION (Continued)

WIPER LINKAGE

REMOVAL
(1) Remove wiper module refer above (Fig. 9).
(2) Disconnect wiper arm linkage, by insert screw-
driver between ball cap and linkage, then twist the
screwdriver and lift straight up on linkage.
INSTALLATION
For installation reverse the above procedures.
Using pliers or hand press the ball cap straight on to
the ball stud.

WIPER MODULE

REMOVAL
(1) Remove wiper arms and blades (Fig. 9).
(2) Remove the rear hood seal with the cowl top
plastic screen.
(3) Disconnect motor wire connector at front ple-
num wall.
(4) Remove wiper module mounting screws and
remove module.
MOTOR CONNECTOR
INSTALLATION
For installation reverse the above procedures.
Tighten the mounting screws to 7 to 9 N·m (60 to 80
in. lbs.) torque.

WIPER MOTOR

REMOVAL
screwdriver between crank and linkage then twist
the screwdriver and lift straight up on linkage.
motor.
INSTALLATION
reverse the above procedures. Tighten the motor
mounting screws to 5 to 6 N·m (45 to 55 in. lbs.)
torque. Tighten drive link nut to 11 to 12 N·m (98 to
106 in. lbs.) torque.

WIPER SWITCH

REMOVAL
shroud and remove upper half of shroud (Fig. 10).
switch.
INSTALLATION
Fig. 9 Wiper Motor and Linkage Module
(1) Remove wiper module refer above.
(2) Remove linkage from motor crank. Insert
(3) Remove motor mounting screws and remove
For installation add unilube grease to socket and
(1) Remove three screws holding steering column
(2) Remove mounting screw on switch and remove
(3) Disconnect wire harness connector from switch.
For installation, reverse the above procedures.
PL
MOUNTING WIPER MOTOR MOD- WIPER ARM NUTS GROUND COWL SCREEN STRAP CAPS ULE