Chrysler neon 1997 Service Manual page 613

POWER STEERING POWER POWER STEER- PUMP BRACKET PUMP ING PUMP STEERING POWER MOUNTING BRACKET STEERING
19 - 24 STEERING
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 36 Pulley Removal From Power Steering Pump
INSTALL
CAUTION: Do not hammer on power steering
pump pulley or shaft to remove power steering
pump pulley. This will damage the pulley and the
power steering pump.
(1) Mount power steering pump in a vise using the
power steering pump mounting bracket (Fig. 37).
Then place power steering pump pulley squarely on
end of power steering pump shaft. Mount Installer,
Special Tool C-4063 in internal threads of the power
steering pump shaft and against power steering
pump pulley (Fig. 37).
Fig. 37 Pulley Installation On Power Steering Pump
(2) Ensuring that special tool and pulley remain
aligned with pump shaft, force pulley onto power
steering pump shaft until flush with the end of the
shaft (Fig. 38). When pulley is flush with shaft
tool will no longer be able to be turned.
PUMP POWER STEERING PUMP PULLEY SPECIAL SPECIAL TOOL C-4333 OR ING PUMP PUL- POWER C-4063 TOOL WRENCH STEER- WRENCH
Shaft
Shaft
LEY C-4068 POWER STEERING
Fig. 38 Correctly Installed Power Steering Pump
(3) Remove Installer, Special Tool C-4063 from
power steering pump.
(4) Install power steering pump and mounting
bracket back on engine. Refer to Power Steering
Pump Installation in the Power Steering Pump Ser-
vice Procedures section in this group of the service
manual for required procedure.
POWER STEERING PUMP MOUNTING BRACKET
DISASSEMBLE
(1) Remove power steering pump from engine.
Refer to Power Steering Pump Removal And Instal-
lation in the Power Steering Pump section in this
group of the service manual for required procedure.
CAUTION:
pump pulley or shaft to remove power steering
pump pulley. This will damage the pulley and the
power steering pump.
(2) Mount the power steering pump in a vise using
the power steering pump mounting bracket (Fig. 39).
Mount Puller, Special Tool C-4333 or C- 4068 on
power steering pump pulley (Fig. 39). Remove the
power steering pump pulley from the power steering
pump shaft.
(3) Remove the 3 bolts attaching the power steer-
ing pump to the mounting bracket (Fig. 40).
(4) Remove power steering pump from mounting
bracket.
ASSEMBLE
(1) Install power steering pump on mounting
bracket. Install the 3 power steering pump mounting
bolts (Fig. 40). Torque the 3 mounting bolts to 54
N·m (40 ft. lbs.).
SHAFT PUMP SHAFT AS SHOWN TO CORRECTLY LEY MUST BE FLUSH WITH PUMP HUB OF POWER STEERING PUMP PUL-
Pulley
Do not hammer on power steering
POWER POSITION PULLEY PUMP PULLEY STEERING
PL