Trunk Lamp/Lens; Vehicle Speed Sensor - Chrysler neon 1997 Service Manual

PL
REMOVAL AND INSTALLATION (Continued)
(2) Remove the attaching screw from each of the
two forward cup holders of the floor console. Remove
the screws at the rear of the console or inside of the
armrest console bin.
(3) Pull the parking brake lever all the way up.
(4) Lift the floor console at the rear high enough to
gain access to the lamp and socket.
(5) Remove the indicator lamp socket from bezel to
replace the lamp.
INSTALLATION
For installation, reverse the above procedures.

TRUNK LAMP/LENS

REMOVAL
The trunk lamp snaps into the rear shelf panel
reinforcement under/below the package shelf.
(1) Remove the socket assembly by reaching up
above the sheet metal. Push the snap inward and
downward and remove the assembly.
(2) Remove the lamp from socket and pull the
socket from the lens. Replace as necessary.
INSTALLATION
For installation, reverse the above procedures.

VEHICLE SPEED SENSOR

REMOVAL
(1) Remove the harness connector from the sensor
and make sure the weather seal is on the harness
connector.
(2) Remove the sensor retaining bolt.
(3) Pull the sensor and pinion gear assembly out of
transaxle. If necessary, carefully pry it loose with a
flat blade tool (Fig. 31) and (Fig. 32).
INSTALLATION
For installation, reverse the above procedures. Seat
the sensor assembly by hand to ensure proper gear
engagement. Tighten retaining bolt to 7 N·m (60 in.
lbs.) torque.
SENSOR RETAINING BOLT SENSOR CONNECTOR VEHICLE SPEED SENSOR TRANSAXLE EXTENSION SENSOR RETAINING BOLT
INSTRUMENT PANEL AND SYSTEMS
Fig. 31 Vehicle Speed Sensor and Connector
Fig. 32 Vehicle Speed Sensor and Speedometer
TRANSAXLE EXTENSION VEHICLE SPEED SENSOR SPEEDOMETER PINION
Pinion
8E - 17