Chrysler neon 1997 Service Manual page 491

MAKER PUMP APPLY OIL FILTER ADAPTER TO OIL PICK-UP TUBE FLANGE GASKET OIL PAN GASKET OIL PUMP BODY BODY OIL DRAIN PLUG OIL PAN O-RING O-RING O-RING NIPPLE FILTER
9 - 78 2.0L DOHC ENGINE
REMOVAL AND INSTALLATION (Continued)
(6) Remove oil pump, (Fig. 74) and front crank-
shaft seal.
INSTALLATION
(1) Make sure all surfaces are clean and free of oil
and dirt.
(2) Apply Mopar Gasket Maker to oil pump as
shown in (Fig. 75). Install oil ring into oil pump body
discharge passage.
Fig. 75 Oil Pump Sealing
(3) Prime oil pump before installation.
(4) Align oil pump rotor flats with flats on crank-
shaft as you install the oil pump to the block.
NOTE: Front crankshaft seal MUST be out of pump
to align, or damage may result.
O-RING
Fig. 74 Oil Pump and Tube
PROTECTOR
(5) Torque all oil pump attaching bolts to 28 N·m
(250 in. lbs.)
(6) Install new front crankshaft seal using Special
Tool 6780 (Fig. 76).
Fig. 76 Front Crankshaft Seal—Installation
PL
INSTALLER TOOL 6780–1 SPECIAL
SEAL