Chrysler neon 1997 Service Manual page 438

DRAULIC LASH ADJUSTER EXHAUST ROCKER ARM/HY- RETAINER SPACER ASSEMBLY CAMSHAFT SEAL SPARK VALVE RETAINING LOCKS
ROCKER SHAFT AIR INLET DUCT RETAINING
BOLT
PL
REMOVAL AND INSTALLATION (Continued)
Fig. 32 Air Cleaner Inlet Duct
• Fourth Turn an additional 1/4 Turn, Do not use
a torque wrench for this step.
For the rest of installation, reverse removal proce-
dure.
PLUG TUBE SEAL VALVE SPRING RETAINER
Cylinder Head and Valve Assembly
CAMSHAFT INTAKE ROCKER ARM/HYDRAULIC LASH ADJUSTER ASSEMBLY FEELER VALVE GAUGE SPRING SEAT ASSEMBLY SPACER SEAL AND VALVE SPRING VALVE
Fig. 33 Checking Cylinder Head Flatness
TIMING BELT COVER
REMOVAL
(1) Remove accessory drive belts. Refer to Group 7,
Cooling System for procedure outlined in that sec-
tion.
(2) Raise vehicle on a hoist and remove right inner
splash shield (Fig. 35).
(3) Remove crankshaft vibration damper. Refer to
procedure outlined in this section for removal.
VALVE ROCKER RETAINER SPACER ARM SHAFT
2.0L SOHC ENGINE
STRAIGHT EDGE
9 - 25