Chrysler neon 1997 Service Manual page 342

WASHER RESERVOIR WASHER PUMP FILLER NECK
PL
Fig. 4 Washer Fluid Reservoir
REMOVAL AND INSTALLATION
WASHER NOZZLE
REMOVAL
(1) Disconnect washer fluid hose at the nozzle.
(2) Using a needle nose pliers, squeeze together
the locking tabs on the nozzle (Fig. 1).
(3) Remove nozzle.
INSTALLATION
(1) Place the nozzle in position and push down-
ward till locking tabs are securely snapped into posi-
tion.
(2) Connect the washer hose and ensure that the
hose is not kinked.
WINDSHIELD WIPERS AND WASHERS
Fig. 3 Windshield Washer Test
WASHER RESERVOIR
REMOVAL
(1) Remove filler neck (Fig. 5).
(2) Raise vehicle on hoist.
(3) Disconnect the wire connector from the reser-
voir pump (Fig. 6).
(4) Disconnect the washer hose at the pump and
drain the reservoir.
(5) Remove fastener from reservoir.
(6) Remove the reservoir through fender opening.
INSTALLATION
For installation, reverse the above procedures.
Tighten the reservoir screw to 2.2 to 3.3 N·m (20 to
29 in. lbs.) torque.
FILLER NECK
Fig. 5 Filler Neck Removal
8K - 9